STATE=OFF, FORCESTATEACTIVE=X0, TXAFTERFRAMEPEND=X0, TXENS=X0, RXENS=X0, TXAFTERFRAMEACTIVE=X0
No Description
| RXMASK | Receive Enable Mask |
| FORCESTATEACTIVE | FSM state force active 0 (X0): No special state transition is currently in progress 1 (X1): A forced state transition is currently in progress |
| TXAFTERFRAMEPEND | TX After Frame Pending 0 (X0): A transmit after frame operation is currently not pending. 1 (X1): A transmit after frame operation is currently pending. |
| TXAFTERFRAMEACTIVE | TX After Frame Active 0 (X0): The currently ongoing TX was not initiated by a TXAFTERFRAME command. 1 (X1): The currently ongoing TX was initiated by a TXAFTERFRAME command. |
| SEQSLEEPING | SEQ in sleeping |
| SEQSLEEPDEEP | SEQ in deep sleep |
| STATE | Radio State 0 (OFF): Radio is off 1 (RXWARM): Radio is enabling receiver 2 (RXSEARCH): Radio is listening for incoming frames 3 (RXFRAME): Radio is receiving a frame 4 (RXPD): Radio is powering down receiver and going to OFF state 5 (RX2RX): Radio remains in receive mode after frame reception is completed 6 (RXOVERFLOW): Received data was lost due to full receive buffer 7 (RX2TX): Radio is disabling receiver and enabling transmitter 8 (TXWARM): Radio is enabling transmitter 9 (TX): Radio is transmitting data 10 (TXPD): Radio is powering down transmitter and going to OFF state 11 (TX2RX): Radio is disabling transmitter and enabling reception 12 (TX2TX): Radio is preparing for a transmission after the previous transmission was ended 13 (SHUTDOWN): Radio is powering down receiver and going to OFF state 14 (POR): Radio power-on-reset state |
| SEQACTIVE | SEQ active |
| TXENS | TXEN Status 0 (X0): TXEN is not set. 1 (X1): TXEN is set. |
| RXENS | RXEN Status 0 (X0): RXEN is not set. 1 (X1): RXEN is set. |